LongWave
surface fluency instrument
turn any projector & any wall into a programmed environment · calibrate in seconds · add invisible layers · coordinate across multiple projectors from one phone
where does this fit for you?
also for
your environments
longwave · a surface fluency instrument · v5.2
connected as a node
attach this phone to a projector · AirPlay / HDMI. The operator will send commands here to warp and project content.
share this code with the operator
——
waiting to join a room…
node · —
LongWave
point at any projection
decoded from light
LongWave a surface fluency instrument
idle
Point your camera at the wall.
Hold the phone steady. The engine learns the surface from what it sees. When it locks, you're ready — or skip this and tune by hand.
confidence
—
residual
—
warp rms
—
tap a handle to select · use the pad to nudge
pick a content source
source warp aspect
ready when you are
pick a source and a surface
brightness 1.00
contrast 1.00
no surfaces yet
calibrate or tune to save a surface.
room
two phones enter the same code and see each other · invisible data projected by either phone is readable by both
message to embed invisibly
• rides inside projected light · invisible to eyes · readable by any phone camera pointed at the wall
try a scenario
embedding
off
message
0 B
frames
1
streaming
—
enable embedding · go to the project tab to start fullscreen · the invisible signal travels with your content
tap a tool · tap the stage to place · drag to move · tap an item to select
speakers are scaffolding for spatial audio — coming thursday
nodes in this environment